MOATES FLASH AND BURN DRIVER

Once you do have it on a COM supported, go back to the port setting tab and then select the Bits Per Second tab and change it from to then hit okay this is optional. If your burner fails to erase several different chips, you probably have fake chips. Read Chip – This will perform the action of reading the chip. For more information, see “Advanced Addressing”. Try another chip purchased from us, xenocron. Check and make sure the chip is inserted firmly in the socket.

Uploader: JoJozilkree
Date Added: 4 June 2005
File Size: 14.30 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 78867
Price: Free* [*Free Regsitration Required]

Try another chip purchased from us, xenocron. To File – To read a chip to a file: At this point, you have a blank chip correctly inserted in your burner with the correct chip type selected. While you are under the ‘advanced’ tab, make sure the ‘Latency’ is set to ‘1’ and not ’16’. If you see this, you are DONE and the chip is programmed correctly! These settings are important because most of the chips used in ECUs xnd a smaller capacity than the chip you are programming.

Current time is 9: Burh blank checks is a common sign of fake chips. Read Chip – This will perform the action of reading the chip.

Using the Flash & Burn

The next step is to load the file you want to program to the chip. In most cases, the software will automatically set these for you. The following table summarizes what offsets you need to use depending on chip used and file size: This reads the chip into the local buffer. Fire up our Flash n Burn software. Make sure it says device enable, then click port settings tab, then click the advanced button located in the middle.

  HP PAVILION TX1410US WIRELESS DRIVER DOWNLOAD

A short list of chip addressing settings: Supported Chips – This is the list of support chips for reading and writing some may be read or write only and will be indicated in the list. Get out your burner and a chip.

The chip gets read into the buffer, flasy the buffer gets saved to file. Without him I would have not figured out how to make this burner work with this software period. Check and make sure the chip is inserted firmly in the socket.

The New Hardware Found prompt should pop up and then go through the wizard, but when you get to the prompt where you can change to where the file is located, select the folder where you unzipped the usb files and let it finish installation. Everything was wrapped and neatly packed in the middle of the box. Switching adapters use chips that are larger than an ECU requires, allowing the extra space to be used for multiple programs.

For more information, see “Advanced Addressing”. Also, input the address within the chip that you’d like that portion of the buffer to be programmed to. Select it, and it will be loaded to memory on the PC. Also make sure the interface and emulation device is selected to AutoProm, once that is selected you can go ahead and hit ok.

  DELL B110 VIDEO DRIVER

You can register the software for 30 bucks later, which I plan on doing soon.

Introduction

Once flah you can go over to the Tools tab, then go to the preference tab. Select the chip you are burning in the top scroll bar. Before you pop in the usb cable, be sure to download the usb files off of the moates.

After all the stuff is done, you are now finally ready to open TunerPro or the standalone Flash-N-Burn program. This is up to you. Once you have restarted the CPU, you have to double-check some flazh to make sure everything is tip top shape.

Note – All addresses and filesizes must be 64 byte aligned. Both of these cases will be covered in this article.