KONICA MINOLTA 7085/IP-602 DRIVER

Tighten the allen screw holding the actuator plate to the drive shaft. Record the transfer current reading and lower by The travel limit of the bypass gate is set by 2 rubber pads on the “gate” located just above the bypass gate. However, some printing functionality can be obtained using the following recommendations: Set the individual tray for Thick Paper mode. ECM data edit] on the touchscreen.

Uploader: Akitilar
Date Added: 14 July 2009
File Size: 64.4 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 41539
Price: Free* [*Free Regsitration Required]

Please confirm that the PCI slot boards are installed as follows: Access the 36 mode screen by powering the machine ON while pressing the 3 and 6 keys. Solution The FS can staple a maximum of sheets.

This sensor is located on the rear of the finisher slightly below the upper pulley for the exit tray wire. The Printer pre-regist adjustment was set to 4 instead of 3.

Konica Minolta /ip Driver | Konica Support

Normal output should be 36VDC. Turn the allen screw of each hinge seven turns 7 in the counterclockwise direction to apply maximum tension to the RADF lift springs. The dipswitches on the PZ control board are set for the wrong model. A poor connection between the parameter memory board and the image control board or poor connections on the image IF board.

  IR5000 6000 PCL6 DRIVER DOWNLOAD

Remove the metal cover and scratch the surface of the disk using jeweler’s screwdriver or similar device. This error will be corrected in the next service manual update.

Konica 7085 Konica IP-602 Konica IP-602M Konica Minolta Force… Drivers Download

Series is 90lb white index and is 9x The 11×17 image can not be centered on the 12×18 paper. High voltage adjustment consists of the following: Memory switch setting] on the touchscreen.

Use the down arrow on the right of the screen to select [ OPC drum]. A failed firmware flash process, possibly caused by corrupt firmware files or minolya poor parallel cable connection between the PC and Select [19] Scan transmission setting.

Power the machine OFF. Select or check-off the bit x64 driver to be added to the bit server. Check the RADF to ensure that it remains in the raised position when lifted from the platen glass.

If 25 mode is set to a 1, the following options are available: The IP will then reboot automatically. If PS changes state, then the wiring is reversed. Scroll to dipswitch using the arrows. Please help us maintain a helpfull driver collection. Scanning to the hard drive in PDF minolya requires 25 mode dipswitch be set to 1.

  CRAFTSMAN 19.2 V IMPACT DRIVER

Konica Minolta Ip Ps was fully scanned at: Solution Please perform the procedures mentioned in the attached document. Reassemble the ADU in the reverse order of disassembly.

Check the printer pre-registration. Next, check CN pins on the power supply lonica board. This setting works in all three scan modes: June 60 The display locks up during warm up with no failure code.

Select Edit and then Preferences.