Other scenarios where you might want to reset your router is if you’ve forgotten the password or misconfigured it and can’t get access anymore. When the router finishes restarting, check to see if you can get online. Wait about 30 seconds, and try getting online. If you have performed a reset of your WCR-G54 device or not changed the defaults, you should be able to access it with the following settings:. From there, click on the compatibility and click on “Run As Administrator” and “Run this program in compatibility mode for Vista” then click apply. Try setting it up manually. If you are not sure which type you have, you can contact your Internet Service Provider, and verify which type you have.
|Date Added:||16 September 2014|
|File Size:||39.37 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
In the output, locate the section that contains information about your network connection. On the Diagnostic page, click on ‘release’. The device you use to determine a router’s IP Address must be connected to the network, either wirelessly or wired bjffalo a cable.
What I did was: Click the name of the connected wireless network.
Buffalo WCR-G54 Settings
If you follow the above directions it should work. Hard reset instructions for Buffalo WCR-G54 If your WCR-G54 router is not working as it should, dropping connections or not being responsive, you should first do a reset of the router to bufalo if the problems persist.
After the setting is oruter and the router finishes rebooting, unplug it from power. There should NOT be a green bridge led illuminated it looks like a green arch.
How can I make use of it? Once it finishes booting, check to see if you can get an internet connection.
Do I have to return it because your product software was not up to date or obsolete? This process usually works for resetting any router to it’s factory setting. First, unplug the cable modem from power for at least 5 minutes.
If not connect your computer directly to your modem and see if you are getting internet from it. Router Specs Factory reset instructions Default settings Similar routers.
First log into the Buffalo router http: I still go back to using Vista. RAID arrays can fail.
Wait about 30 seconds, and try getting online. I’m also bucfalo Windows 7. From there open the folder and look for an. The Power LED should be illuminated.
Try setting it up manually. Then follow these instructions:. The instructions vary, depending on your operating system. Please login or register.
If you have performed a reset of your WCR-G54 device or not changed the defaults, you should be able to access it with the following settings:.
Buffalo / WCR-G54 : Router IP Address
Then unplug the power from your modem for 5 minutes. From there, click on the compatibility and click on “Run As Administrator” and “Run this program in compatibility mode for Vista” then click apply. Now I can use it on Windows 7. Plug in the cable modem to power and wait for it to fully boot up. Plug the WAN port of the router into the cable modem and then plug it into power.
Once the DSL modem has been power off for 5 minutes, power it back on. It is worth reading more about how to reset routers with the 30 30 30 reset and what the risks and considerations are when resetting your router this way, instead of just rebooting it.